Recent content by abeinnz

I thought as much, thanks for your reply. Much appreciated!

Hi, this is probably a really simple answer but I've been doing some digging and can't seem to find anything obvious so thought I'd ask as anyone familiar with PoE will likely know. I have a main managed switch (TP-LINK TL-SG2424) that runs my home network. I'm looking to add some Wireless AP's...

Thanks everyone again for your help. I've managed to determine that it was the switch that was the issue. Turns out the switch was operating at 192.168.0.1 after a factory reset some time ago and the DHCP was in 192.168.1.x range. That's why I couldn't access the management page. I've now...

Thanks everyone for your suggestions and comments. Much appreciated. I must clarify a mistake of mine, I'm actually using cat6, not cat6a. The confusion with the 'a' is that here in NZ the standard is 586A, not 586B. Now I know a bit about cat6a so thanks for that, too. As mentioned yes, I...

I'm using a Master NSHL468. It's likely continuity testing only but the guide does say if the pin connection is bad then the LEDs won't light. I'm not sure what the tolerance is, however.

I've completely wired my house with cat6a config sockets. All jacks are tested and all custom made cables are also tested with a network testing tool. I made a couple of new cables today, both tested fine but when connected to my PC I get no internet and the adapter is only negotiating to...