Recent content by addisonross33

Okay so currently I have my processor capped at 4.7ghz so in blender and cinebench the temps now only reach about 77c or so, and there is very VERY little performance drop

https://ibb.co/0F7LjrZ

Unsure if any of these settings seem off. Also included an image of voltage and cpu speeds at idle. It seems like it was jumping all the way from 800mzh to 5ghz while just on the desktop. https://ibb.co/hXkFJSM https://ibb.co/0F7LjrZ (ALSO just an FYI thank you everyone who has given me...

So just ran cinebench again for 10 mins after changing the fan curve in bios and the highest it went to now is 81c, with most cores being around 77c! I tried to do the 'edit power plan' thing, but even by changing to 99%, the speed of the processor decreased to about 3.4ghz all the way from...

It bounces up and down a little bit, by around 5C on any given core I would say

So the highest it got up to today in cinebench was 87c and that was in a relatively warm room at about 28c ambient temp. Just wondering, if I were to render something that took several hours or perhaps overnight, would a temp of 87c be sustainable for this processor? Just worried about damaging...

Okay, so I removed the two front fans and replaced them with the exhaust fans (since i think they are better, higher rpm) and took the front panel off, and during cinebench testing for 10 mins it didn't increase by more than 84c. Blender also didn't increase by more than 82c. These temps should...

About 200-208w when running Cinebench

Okay so admittedly I forgot to install the new bios, but I just did that and while it seems to have solved the 4.9ghz thing (It's currently doing cinebench at 4.8ghz now on all cores) the temps haven't changed. Everything else is up to date though. Here's my fan set up: https://ibb.co/5WzFXRV...

My bad! My case is a Deepcool Macube 310p Also, it seems no matter what i'm doing, all the cores are at 4.9ghz? Even right now they are at 4.9ghz at idle, doing nothing. And no Dragon Centre installed and balanced power setting is already one :) (EDIT: Clock speeds are still at 4.9ghz for all...

Hi guys, Kinda stressed out here. I built a new computer with an I9 10850K and am using a Noctua NH D15 to cool it. The idle temps are pretty fine IMO, at around 35c - 40c. But when using Blender for rendering or running Cinebench, the temps go REALLY high pretty fast. Highest I have seen it go...

I was looking and I think I can probably afford a Corsair RM750x, as far as I can tell it's quite good. Think that would be alright?

Hi guys! Was just wondering the question in the title. The power supply is a Thermaltake Toughpower 650w GOLD (not RGB or anything). I'm currently running the 3070 already with an I7 6700k, and the TDP will increase by 34W for the CPU. Will this be alright?