Recent content by Alessuk

  1. A

    [SOLVED] Freshly built PC and issue with BSOD

    I think it's solved. Didn't got any BSODs so far. I've checked in CPU-Z that my RAM is operating at 2600. I did this MemTest you linked, the result is that both pass the test over 200% coverage. Thanks @drea.drechsler and @dorsai !!!
  2. A

    [SOLVED] Freshly built PC and issue with BSOD

    Good! I'm gonna run this another test asap. The Windows Memory Diagnostic I've ran already and didn't got any errors. Other thing I'm looking forward is to change my PSU. I think I'm gonna switch to Corsair CX550 that's matching my budget. lol
  3. A

    [SOLVED] Freshly built PC and issue with BSOD

    Hello! I did change DRAM Voltage on BIOS today. The default setting was 1.20V and the right voltage for XPG Spectrix is 1.35V, like you guys said. Before changing the voltage another BSOD occurred, this time the BugCheck name is PAGE_FAULT_IN_NONPAGED_AREA. I've found in the article here that...
  4. A

    [SOLVED] Freshly built PC and issue with BSOD

    Today, two BSODs: BugCheck name: KERNEL_AUTOBOOST_INVALID_LOCK_RELEASE BugCheck code: 0x162 Caused by: ntoskrnl.exe That's the message you are referring for? Sorry if I mistake something, English isn't my mother language. ^^
  5. A

    [SOLVED] Freshly built PC and issue with BSOD

    Yes! I did a clean install, just setup boot to SSD in Bios, since I'm using and SSD and HD. I didn't change anything else. No XMP, so I'm using the memory in 2600MHz even if supports 3000MHz. I was planning to enable XMP, but I didn't.
  6. A

    [SOLVED] Freshly built PC and issue with BSOD

    3 hours after running Memtest86 the result is:
  7. A

    [SOLVED] Freshly built PC and issue with BSOD

    Firstly, thank you. As I've said before, I already reset my PC/Windows and I'm still getting problems with BSOD. I already upgrade all my drivers by using the last version available on the fabricant website, also I took the PC to assistance in order to discard hardware problems (technical said...
  8. A

    [SOLVED] Freshly built PC and issue with BSOD

    I've repeated this command and turns out any defective file.
  9. A

    [SOLVED] Freshly built PC and issue with BSOD

    I did not set any memory timings or voltage. I'm not using XMP also. I'm using SSD Crucial BX500, 240GB, SATA and HD Seagate BarraCuda, 1TB, 3.5´, SATA. Windows 10 is installed/running on the SSD.
  10. A

    [SOLVED] Freshly built PC and issue with BSOD

    Hey guys! My PC has the specs below: Asus Prime B450M Gaming/BR AMD Ryzen 5 3600 2x8Gb RAM XPG Spectrix 3000MHz EVGA Nvidia Geforce GTX 1650 SC Ultra EVGA 650W 100-N1-0650-L Ive bought and installed Windows and after about 3 months of use started to have many BSODs (more than 2 per day)...