Recent content by ambiguousmoth1337

K thanks I'll try that and see.

So also upgraded my ram to the above mentioned, and I understand that the motherboard by default clocks the ram to 1333 mhz My motherboard is a sabertooth 990fx r2.0; while in the bios I found the overclock to 1333/1600/1866 mhz is that what I switch and is it safe? Thanks everyone in advance.

when you get to the installation window, it will bring you to the partion configuration and you do it there.

Yes, when you format a HDD everything is wiped off of the drive. I take it you are using 7 if not let me know, but take your windows 7 installation disk and put it into your drive. After that restart your computer, and hold down either f11 or f12 can't recall. After you find out which one works...

Yeah you need to put the new motherboard in, then put the os boot disk in your cd/dvd drive. That new motherboard won't pick up the flash drive because it needs the drivers installed.

when you have the new board and you were trying to load the same os on the hdd from the old board that would be causing your problems. So just format, re-install and you should be up in no time.

Ok when you put the new motherboard in there you have to format your hdd, and then install the os again.

No I did use google, but just couldn't find out much besides someone you use a cpu to mine :(. Also thanks for the information so far. Lastly is it worth doing?

not sure if this is the right category, so sorry if it isn't. So my question is how does cpu litecoin mining make you money? Is it legal, etc?

Yeah that was what I was wondering thanks for the help everyone!

Really hmm see the reason I asked is at first I bent a few more pins in the centerish, in all 15 pins got bent. It took hours to get it fixed, but since it's running that means the cpu is 100% then right? Thanks for the help.

With my last up grade my new fx 8350 4.0 eight core processor slipped out of my had, and only fell a few inch's at most. So it bent some pins, which I was after hours able to fix. That was a month ago and my comp runs perfectly. Since some pin's got bent will that affect it even if it fit in...

ARe you saying you have ram in all four slots? Also are they all the same speed? Finally take all but one stick out and try to boot, if it crashes go onto the next stick until you have tried all four. If onetime it boots that stick is good, if it doesn't boot then that stick is bad.

sounds like bad ram.

What error message does it display? It would be a series of 0000's