Recent content by Blastphemy

Under high load, in an open bench setup it did not go above 74C at default fan curve. With a custom fan curve 52%speed instead of 40% fan speed) it did not go above 61C

For the cpu, I would recommend the i9 10900k. 2 years newer, and it is around 80-100$ more in price, at a way better performance.

For the fans, I would recommend the Noctua NF-P12 redux-1700 PWM, High Performance Cooling Fan, 4-Pin. they are great fans, and super quiet.

Yes, I made sure to have 1 in the master port. Auto works fine atm, but I never seen the rpm go above 800, when the fan cap is 1700 rpm. Perhaps because it did not need it, since the temps stay low. Thank you very much for all the insight!

Yes, I tried it and it still freezes. How the setup is as follows: the aio pump in cpu fan, the noctua in the silverstone (the silverstone is connected to usb 2.0 on mobo and fan 1, 4 pin on mobo) and the corsair node is connected to fan 3, 4 pin on mobo, and sata, while the corsair fans...

So how the hubs are configured is there is 1 master fan and rest are slaves. As in 1 fac controls the rest. I do believe this might be the issue. I wonder if I remove all the slave fans and set pwm only for master, then plug them back it would work.

I did not miss it, great reply. So the mobo is gygabite z490 gaming x. I am trying to put the fans on pwm mode, but when I do that in bios, and I try to save and quit, my bios freezes, and I have to force boot it. Do you know what might cause this issue? The fans are on 2 different hubs, one...

Setup

Hey everyone. My setup is as follows: - Lian li o11 d -i9 10900k -pny 2080ti blower 64 gb gskill trident z, 3600 mhz Currently have the 360 mm aio top mounted with 6 noctua nf-p12 in a push pull config set to exhaust, and 3 corsair QL on the side mounted as intake. In games like mw warzone on...