Recent content by brad_47

I just found out that for some reason even tho my windows is install on my SSD. If I uninstall my hard drive my ssd with windows wont start. Also I tried it three times. I don't know If I'm cloning it wrong but I followed this https://www.youtube.com/watch?v=7H7D1HcfY9o : and here a picture of...

Hello all! I was hoping to get this issue sorted asap as my old ssd needs to get return to amazon for a refund. Anyways to the problem. After cloning my ssd to the new one and I then uninstall the old one so it doesnt affect boot up. However when I select the new ssd all it does is show a black...

Recently upgraded from a r9 390 strix to a GTX 1060 6gb strix for temps reasons but geforce experience won't run setup and I really want it to work so I can use shadow play as well. thanks

The pump seems to be dead as there is no vibration on the aio and warm water doesn't seem to transferring to the radiator

It's stays between 84 to 90

I'm using the bios to read the temps and as soon as I load up the bios the temps began as 30* then goes up by 1* every second

I recently install my corsair h100i v2 liquid cooler. But for some reason it isn't cooling my cpu. I've install it currently and put new thermal paste on the processor and It still continues to overheat. I think the pump is working but still what the heck is the problem. I bought this liquid...

I found out that CPU error only happens on asus motherboards and I plug the corsair power connecter into the cpu fan where is said to put it. I'm sure that I've install the cooler properly

The temps start at 35 then continues to rise every second.

The led is working and I have a Asus h81 gamer lga 1150. The I start the pc is says CPU fan error and then jumps into bios and theirs a fan going 1600+ rpm in the bios.

Hello, I just installed my new h100i v2 into my computer but the temps went really high on idle but to be honest I didn't have any thermal paste laying around so I used the one already applied to my cpu. But I notice when I turned my pc on it said no cpu fan detected and temps went really high...

CPU: INTEL I7 4790K GPU: R9 285 MOTHERBOARD: Gigabyte Z97P-D3 Powersupply: Its was a EVGA 750gold and I'm currently using ACE 700w Hard drive: Some old 1TB RAM: 24GB DDR3 Using windows 10 upgraded from windows 7 Anything else I'm missing?

So rencenty my computer was acting up and it wouldn't turn on. I've find the problem and it was the powersupply. I'd replaced the powersupply with an old one I had. The computer fully boots up but shorty after nothing happends. I've tested this without my graphics card and it still happends. Not...