Recent content by cassini_huygens

Sorry for necroing my own post, but I wanted to as least a sort of 'review' for the ML140s. They move a good amount of air through a dust filter, no issues there. However, there is a pretty audible motor noise at speeds beyond 1100-1300RPM (to be expected, just wanted to make that clear). I...

Thank you all for the responses!

Hello! I'm having a problem where too much hot air builds up around the GPUs and isn't properly exhausted which is causing hotter temperatures, so I wanted to see how my front fans were contributing to the airflow. Turns out the stock fans don't really pull much through the dust filter, so I'm...

Hi everyone. I'm looking to install a second GPU dedicated to mining on my motherboard, and had a question about how I would go about configuring the PCIe lanes. Currently I have one RX-470 running in the PCIe3.0x16 slot, and I plan to install the second GPU in the PCIe2.0x4 (physically 16...

Hello everybody, I know I posted a thread very similar to this the other day, but a better card went on sale for the same price. I wanted to add an MSI 1070 Ti Gaming to my setup, and was wondering if my EVGA 650 G2 would be sufficient enough to power it along with the rest of the stuff below...

Hello everyone! I am planning to add an MSI 1070 ARMOR OC to my setup, and was wondering if my EVGA 650 G2 would be able to supply enough power. My current setup is as follows: CPU: i7-2700k RAM: 4x4GB DDR3-1600 Corsair Vengeance MB: GA-Z77-D3H (1.1) GPU: Gigabyte G1 RX470 (I am planning on...

Hey, I'm looking to replace my CoolerMaster Hyper N520 with another tower cooler that would have 4 pin PWM support, and be less than or equal to 160mm in height (heatsink and fan included). As for RAM, I'm using a 4x4 Corsair Vengeance DDR3 memory with the tall decoration fins, so that may make...

The hottest core (core 3 in my case) never goes over 80°C in the entire duration of the stress test.

What do you think a solid frequency for my processor would be with as much longevity in mind?