Recent content by cgipperich

So I'm looking at this monitor currently:http://m.newegg.com/Product/index?itemnumber=N82E16824009728 I wish the refresh rate was higher but, as we discovered, that drives up the price quite a bit. Also, 16.7 million colors represented....I've seen a few that are over a billion but I'm...

Is there a big difference in color representation, luminance and color fall off when it comes to a TN monitor versus an IPS monitor? Is that going to hurt me a lot when it comes to editing?

So it seems I'm going to have to cut some corners on what I was originally looking for, which is to be expected. I'm looking at that Acer monitor you sent me and I like everything except for the refresh rate. Personally, do you see any problems with gaming on 60 Hertz? I know the most serious...

Gosh that price increase is significant. I'm assuming free sync does not work with my GPU correct?

Let's see it.

That one is close for sure. Do you know of any that have these specs but G-Sync or 100/120hz for a little more money?

Darkseiders, Thanks for the reply. I'm sorry I neglected to put my price range in my post. I'd like to keep it under $400 if I could. I'm not completely sure how hard that will be given the specifications that I'm shooting for. Is $400 unrealistic? I'm also hunting newegg's deals so maybe...

Awesome! Thanks so much! So is it a good idea to leave XMP enabled as I have it now?

Just reinstalled it and its working now. Under memory, it says 16gb DDR4 dual channel with about 1600MHz DRAM frequency and 800MHz NB frequency.

I get an error message when I attempt to start the program, and the memory to have is totally blank except for the size. It shows nothing for the type.

I was able to get the keyboard working if I unplugged and plugged it in during the boot up on a splash screen. So the BIOS install worked but my RAM. is still reading incorrectly. I went into BIOS and enabled XMP and set it to ddr4 3200 but here's what I end up...

I rebooted and my keyboard lit up during the splash screen. I try to enter BIOS but the anti-surge screen came up and my keyboard is off again. So I am unable to run setup as it is telling me to do.

Tradesman, Just went through the bios update and it said it updated successfully and then restarted itself a few times to finish the install. It then booted and showed me the Asus splash screen which I assume to mean that the install is finished. It must have reset my BIOS setting ls because...