Recent content by fahd.grad

Asrock technical team seem to have a different opinion: Asrock reply: Hello Fahd, Try the memory in one slot, because I had a similar issue on AB350 board, and it turned out that there was a problem with the memory module. But I think it's the combination of the memory controller and the chips...

jojesa I see from your title that you have ryzen 5 1600 plus 3200mhz ram did you face any issues with your ram, I have contacted asrock and they advised me to return the ram as its faulty I have logged an rma with the retailer.

Internet problem solved. This how i solved the internet problem: 1. connect to your router with other devices and check the internet speed by going to www.speedtest.net, if your connection is fast then you have eliminated network and router issues. 2. Connect your pc to the router by wired and...

update on problems: Ram problem: I have tried to load xmp 2.0 profile and tried these freq 3200,3100,3000,2993 and 2800, they all crashed except of the 2800 however when I play call f duty for more than an hour it crashes too. I have selected 2663 for now so far no issues I guess I will have to...

gpu jammed problem. I reseted the bios today and replaced the ram sticks as I was instructed by g.skill. I used xmp profile at 3200mhz but system kept crashing until I got to 2993mhz and its running fine so far. whilst I was doing that I have noticed that my gpu fans are not turning but am...

will changing the motherboard help achieve the 3200mhz

gpu temp is at 32

my bios is updated to 1.50

those temp where taken after 2 hrs of heavy web surfing with about ten pages open. what temp are considered reasonable??????or idle temp?????? if they are high what is the problem how can lower them.?????? heres what g.skill tech support said: Dear Customer, Due to the Ryzen platform being a...

another thing' my gpu msi amd radeon rx 580 8gb armor 8g oc graphics card when I first installed it I thought that the fans have red led light up but no theres no light!!!!!! I don't know if am paranoid but how can I find out if it has fans red led or not coz right now they not lighting up, I...

I have been running my computer for over 2 hrs now and here are the temp: cpu temp = 57c m/b temp = 28c vrm temp =29c I have contacyed cooler master for spare screws awaiting their reply, I just hate dismantling everything again. I have been running the ram speed at 2800mhz so far no problem...

Another thing is that when I was installing the mountings for my cooler master212 led turbo I broke one of the mounting screws so the cooler is supported by three mounts instead of four. I’d this a problem worth rectifying ? If so where can get the screw mounts from?  

HERES A LINK for ram https://www.gskill.com/en/product/f4-3200c16d-8gvkb

Update. I tried to run the system again and walla successful post. It turned out to be a faulty hdmi cable. So I installed everything in the case and booted up everything was fine. I installed a fresh copy of windows 120 home 64bit, I ran into a few issues such as unable to install windows on...

I received my new asrock fatality gaming k4 today from amazon and started building everything from scratch. Steps, 1. Installed the cpu and made sure the triangles line up after consulting the manuals, installed the cooler, GPu and two ram sticks switched on the PSu and no post. 2. Tried booting...