Recent content by Glisen_man

Well i have tried setting all the voltages manually in the bios rather than leaving them on auto.And its not made any difference Next thing i will try is maybe reseating the ram into a different slot

Vsync on or off,still get the slowdown feeling in my games Get the drops from 60 down to 50 occasionally on games i should have no prob playing at locked 60fps. I hate screen tearing but dont bother with Vsync in most games because that minimizes the effects of the problem i experience Cpu...

ok i had my system a while,and this has been bothering me for a while. When i play games,and my FPS rate drops,i get these slowdowns,where a drop from 80 down to 60 makes a game feel like its only like 20fps.Not just that but my the difference between min/max framerate is also quite large in...

Today i installed a CM hyper TX3 EVo to my FX6300 CPU(AM3+),and im unsure as to if my setup is optimal Here is a pic of inside my case http://postimg.org/image/xrwqp9lg7/ Fan on far right, pushes air in,fan on far left pulls air out. The CM pushes air from south to north,this is installed...

I have no AHCI drivers,but i have a 'amdSATA Controller' aswell as 'ATA controllers' so i assume i have got to find ACHI drivers for my MOBO and install them pre-boot?

So i just installed my Samsung 840,and done a fresh install of WIN7.Im pretty sure i got my bios right,when the system starts i now get some info pop up about the ACHI protocol(which obv i never had before) and the drive boots up to win7 no problems.But samsungs software says AHCI mode is...

so i did a test with the setings via the nvidia control panel 1st up i tried CS:GO,constant 60fps,no screen tearing framerate/ms times as expected (16ms constant) Then Anno 2070,no screen tearing, fps was between at 55-60 most of the time,but there was a lot of stutter and and acording to...

So i recently bought an 660(for my new gaming PC) and im having major issues with Screen tearing Im using a 60hz 1080p monitor and obviously i would expect screen tearing when it goes above 60 fps,but it seems Really bad,when i limit the FPS rate to say 59-60 i still get noticeable screentear...

I just got an MSi GTX 660 TWIN Forzr III, its advertised clocl speed is 1098Mhz but when im playing games and MSI afterburner is active(On default settings) it registers the clock speed at 1163. Is this a feature of the card,that it will clock up to what it deems safe? or is my card faulty?

Its a rather basic case,buts theres plenty of room and air flow,the case has 2 extra fans inside,the big one at the back only comes on when im near full load for an exteded period of time.As i said before my case feels nice and cool and puts out a nice breeze of cold air :D Ambeient temp today...

I just got my new rig and im wondering on how to check its all working fine for now,I have a FX6300(Black edition vishera 14mb) with stock cooling and it seems really hard to get an accurate reading on the temps of the CPU I tried core temp/hwmonitor and AMD overdrive Overdrive obv shows...

I just got a new rig,and for the immediate future im gonna have to use my 32' LCD tv as a display. Its primarly gonna be used for gaming and my Graphics chip will be a 660 with outputs for DVI-D,HDMI, and DVI-i My tv is only 1080i and has connections for VGA(PC channel) and HDMI ports...