Recent content by kevroni

Hey there, Thanks for the reply. Yes, the more I think about it the more I am leaning towards thinking the geminii will clunk around and hit components in my case. I actually looked at the cooler you have myself along with the CM tx3 which is also a tower cooler with a 92mm fan. I have a stock...

Hello all, I have a low clearance mini tower, CM elite 343, in which I have decided to replace the stock intel cooler mostly due to noise rather than performance. The geminii s524 meets the height clearance of the case but I am actually worried that width wise it may bump into the back of my...

Perhaps you could try to use the DVI port on your Motheboard initially to display and set-up your software (if you have one of those adaptors). Then install drivers for your video card and switch over to video card display once drivers are properly installed. It sounds like your other...

Check out the walking dead episodes 1-5. I can honestly say I've never been more attached to video game characters and how their story unfolds more than these games. In all seriousness, when I got to the end of episode 5 I almost shed a tear because I cared so much. The greatest emphasis is...

More for fun and curiosity rather than the practical, I was thinking about trying to WC the CPU inside a CM elite 343. I have only seen one other post with someone watercooling inside this case and they put the 120mm rad and fan on the front intake which I don't think is ideal. The rear...