Recent content by koberulz

Surely if one prints in black and white (as in, selecting that in the printer settings, not just as in printing a source with no discernible color), only black ink is used?

But why is the black coming out orange instead of invisible? Your contention is that everything has some amount of magenta and yellow in it, even when printing in black and white? I'm also not sure why a touch of magenta in the blue would make it as saturated as it is. The whole thing just...

And black? Even black and white prints are coming out orange.

If that were true, though, wouldn't those areas come out white?

They're all full, or near enough. The same thing. I printed that page to try and figure out why other prints were looking off.

https://www.printatestpage.com/ Canon G3630.

I'm still not sure what the story is with the rear fan: it's the only thing left in the case at this point that's as old as the case is, so I can only assume that at some point I replaced whatever made it work. It's not connected to the motherboard at all—it doesn't have the correct connector to...

Interesting...that's not what the page I found said. In that case it was correct, though I've now flipped it so it's going both towards the back of the case and away from the heatsink.

Fair enough. Turns out it came with a second set of clips so I didn't even need to muck around with it...and that the original fan had been installed backwards, blowing air into the heatsink rather than away from it.

I would assume they're there for a reason, though, and thus removing them would be a bad idea. They don't seem like the sort of thing I'll be able to stick back down if I take them off.

There appear to be rubber pads glued over the screw heads.

The current fan clips onto the heat sink, it seems nothing like a standard case fan to me? Any answers on this other fan that's wired to the PSU and doesn't run? Can I just unhook it and get some sort of splitter so I can connect two case fans to the one mobo port?

This is all I can find: https://www.ple.com.au/Search/hyper%20212

So I replaced the case fans, and now my CPU fan is making a racket...it's a Cooler Master Hyper 212X, do I need to replace the entire heat sink here? Because that's a whole lot more complicated. Also one of my case fans hooks into the PSU, not the mobo, and just....doesn't ever spin. I have no...

What's the difference between ISO and ANSI?