Recent content by kodak9339

Hello, I wanted to know the exact measurements in inches for the MSI Optix MAG274QRF when the height is adjusted all the way down. Since I have a floating shelf just above my setup (about 19 inches from the table below.) I have read the description that the MSI unit is about 21 inches tall...

It's not really a problem I don't think but... Sometimes (Not all the times) whenever I go to press the button to turn on my PC, it turns off for around 2 seconds and then boots back up - nothing bad happens, it just boots up as normal, no boot loop, no errors, it will never turn off by itself...

So I've built my desktop for about 3 months now, I was working on it and all of a sudden I get a System service exception BSOD, and I was thinking, alright it's a new windows update or either it was a driver update. (since my laptop had a major update recently but not my desktop.) So I went to...

Hey all! I have a HDD that I retrieved from a dead laptop, and I want to put it in a Hard drive docking station, to plug into my other working laptop to get files off. But my only concern is that this is a hard drive from a windows 7 laptop, whereas the files I'll be sending it to is a windows...

That’s good to hear, and thankyou for the fast reply!

I’m planning to plug in Z150 speakers to the headphone jack which is located at the back of my 23 - inch Samsung curved monitor, is this safe to do so?

Okay, got it to boot off the USB stick, just had to disable Fast boot and enabled CSM, then turned off the system and back on again to make it appear. But thankyou for the help, Colif!

Both Fast boot and Secure boot are already enabled. And still nothing shows on the boot Menu (F8).

Hey! So I bought a windows 10 usb flashdrive intended to install windows 10 on my new build. My motherboard is the Asus Rog strix Z390-H. But upon connecting the flashdrive to the computer, the usb is not being detected in boot priority or when I press F8. Is there something I'm doing wrong...

As seen in the second pic though, it’s not very well aligned and the ports are a little to the top.

I have an RTX 2070 card installed in my motherboard in a NZXT H440 case, but the io where the ports are, are not aligned correctly with the case cutouts... like as if the GPU has gone up a bit. And screwing it just makes it worse as it goes higher. Here are some pictures for reference! It’ll...

Okay Thankyou!

So I have the Mastercooler 212 hyper evo in red, upon inspection of the male pins that connect to the double fans. I noticed that one of the cords has a 3 pin whereas the other has 4. Is this normal?

thankyou! so do i need to push it into the io hole if i is on the motherboard?

help, im trying to take the io shield off the motherboard to put in the case, is it suppose to stay on the motherboard or am i suppose to tug it off? Thankyou!