Recent content by Koryboy

  1. K

    R9 295X2 Stuck at 30hz

  2. K

    Stuck at 30hz at 4K

    It is just the 4K resolution being limited to 4K as it is running lower resolutions at 60hz no problem. Also the monitor is linked above and is 60hz compatible at 4K. Its also a fresh windows install and drivers
  3. K

    Stuck at 30hz at 4K

    I am still getting 30hz tho you think the main Display Port might still be faulty?? youd think the adapter would be the cause since signal still gets through goodenough to get me 30hz at 4K
  4. K

    Stuck at 30hz at 4K

    AMD Has No clue what the issue could be other then bad cables
  5. K

    Stuck at 30hz at 4K

    Then how do you get 60hz with an R9 295X2 @ 4k like everyone else does. The Mini DP to DP adapters run full 4K @ 60hz. This Adapter is what I am using. http://www.officedepot.com/a/products/535407/StarTechcom-3m-10-ft-White-Mini/?cm_mmc=PLA-_-Bing-_-Networking_Cables-_-535407
  6. K

    Stuck at 30hz at 4K

    I currently have the R9 295X2 plugged into the ASUS PB287Q. Running a fresh and fully updated version of windows 8.1 as well as the newest recommended AMD drivers from AMD's website. The R9 only has Mini Display Port therefor I purchased a 4K @ 60hz Startech compatible Mini displayport to...
  7. K

    R9 295X2 Stuck at 30hz

    I currently have the R9 295X2 plugged into the ASUS PB287Q. Running a fresh and fully updated version of windows 8.1 as well as the newest recommended AMD drivers from AMD's website. The R9 only has Mini Display Port therefor I purchased a 4K @ 60hz Startech compatible Mini displayport to...
  8. K

    Connectors for R9 295X2 to Enermax Maxrevo 1500W

    Im assuming I haft to ensure it is plugged in the proper section of the red 12pin on my PSU as well? normally the far right portion if Im not mistaken? that leaves it with atleast a ground?
  9. K

    Connectors for R9 295X2 to Enermax Maxrevo 1500W

    The R9 295X2 has to be plugged in with 2 seperate cables and cant be 1 cable leading from the power supply into two 6+2pins . Does that mean I can still plug in the 2 connectors from the GPU into 1 12pin on the power supply or does each 6+2 pin connector from the Graphics card haft to be plugged...
  10. K

    Connectors for R9 295X2 to Enermax Maxrevo 1500W

    So those connectors need to be 6+2 pins to 6 pins for the PSU since the Maxrevo 1500W doesnt have 8 pin PCI slots only 12 pins
  11. K

    Connectors for R9 295X2 to Enermax Maxrevo 1500W

    What connectors do I need to use to plug in my R9 295X2 to my Enermax Maxrevo 1500W PSU? Is it two 6pin to 8pin PCI-E cables? The PSU does not have standard 8-pin connection like the Corsairs tend to. Where can I buy the proper cables that I need? In Canada.