Recent content by KyleIT

Perixx MX-2000IIB --- http://www.amazon.co.uk/Perixx-MX-2000IIB-Programmable-Gaming-Laser/dp/B0083H4NG4 Cant go wrong with this mouse. Feels amazing in your hand

I found a similar motherboard to the broken one and installed the drivers onto it. seems to work fine now.

Same models yes, has been fine for at least four years. (my first PC now family PC) yes, the positive side is face up There was only one ATX12V and it was plugged in I did the minimum config test yeah. Ive had all my HDD's/SSD's disconnected since the start

The computer is say 4/5 years old. Not a single hiccup until now. The motherboard may have just kicked the bucket. Ive built a fair amount of PC's, including this one so i went through the steps on that forum before I posted here.

what's that? what do they do?

Is the a way to find out specifically what's wrong with it? as the fans connected are still working son some aspects may be good. is it a possibility that the board could be saved?

My pc is powering on with the fans moving and the disk drive functioning but it is not launching the bios and/or showing up on my monitor. When the computer loaded it sounded 1 short beep. I've changed the ram over, nothing happened. I've changed the graphics card over, nothing happened. I've...

If you cant connect your pc to the router with a ethernet cable you will have to buy a wireless adapter to connect to the internet. That link isnt working but make sure you have the following; CPU RAM GPU PSU Case Disk Drive Operating system Make sure all of these are compatible aswell. Many...

I have an intense PC (PN: c3217-wb-fm4u) and i am trying to perform a fresh install but when I change the boot order it doesn't save and goes back to like fifth or sixth in line. This is via an external CD drive i should add Any help would be greatly appreciated

You'll need to add a volume to the SSD in disk managment.

See your motherboard manual. It will tell you which two slots will perform the best.

Did you remove your own HDD/SSD from your computer before installing as you may have installed it onto your own storage. If not, then this could be a drivers issue as it they will not be the same as each other.

Please try the following: disconnect everything from the computer, leave on: 1. motherboard 2. one ram module 3. processor with cooler installed 4. power supply unit, pleae do check the general 20-24pin rail connected to motherboard, as well as 4+4 cpu rail

Pandora Recovery worked. thanks alot ASmith426

I've deleted around 200 photos off of my camera and im trying to get them back. I downloaded recuva and did the process but the message I got was; The volume for a file has been externally altered so that the opened file is no longer valid. Does this mean I cant get them back? I'd appreciate...