Recent content by linuxdeveloper.io

Yes, the USB front panel ports are connected to the motherboard USB header. I know this, because two of the USB ports light up the USB stick when I insert it, and the other two don't (because there isn't a second USB header on the motherboard to connect the second two). However, even the ones...

So I figured out a couple things: 1) USB ports on front of case don't work, despite the USB stick glowing on, showing it's getting power. But the front panel USB ports fail to charge anything from these ports, and fails to show up in the OS. 2) I learned finally that the RGB/Fan controller...

I installed the Kingston 2x32GB kit in the DIMMA2/DIMMB2 slots, and again same error - the debug light on the motherboard stays stuck lit on "CPU". I put the original Corsair 2x16gb kit back in and it booted up fine. It seems like the CPU cannot handle more than 32gb of RAM. Disappointing...

So I tested out the front USB ports, and as expected, 2 of the 4 don't power up (because they aren't connected to the motherboard) and the other 2 do powerup the USB stick. However, I can't see the USB stick in Linux for an unknown reason. I might need to reseat the USB connector on the...

I have ordered the Kingston 2x32gb kit and will report back. https://tweakers.net/pricewatch/1729294/kingston-fury-renegade-kf432c16rbk2-64.html

Yes, I upgraded the BIOS and also reset it. Do you need to enable the second lane anywhere in the BIOS? I couldn't find such a setting.

Motherboard BIOS is up to date. I do not see Corsair 2400mhz or 3200mhz, although I do see a lot of other Corsair skus. I will try with a tested solution and report back.

I installed the new 3200mhz ram with 64gb (matched from one new pack) and it wouldn't boot. It has the motherboard debug LED lit up with CPU. I then tried with just 32gb and the same thing happened -- wouldn't boot and stuck on CPU led. None of the new ram worked. I then installed the old...

Thank you. Any ideas on the second part of my question? So far I only have the CPU fan attached and running. The systems fans are not connected.

Is it still possible to add that PCI board, if I already have two full size GPUs installed? Do full size GPUs mean you can't use all the features on the board since it's blocking the socket?

Thanks, I edited my post to correct that the case USB front panel inputs are USB 3.0.

Hello, I have a new Cooler Master C700P case (https://www.coolermaster.com/catalog/cases/full-tower/cosmos-c700p-black-edition/) and so far it has been great. I have two issues: 1) There are four USB 3.0 connectors for the case, with two connectors. My motherboard only has one of these headers...

I miss the low prices of newegg. I am in Europe, so I only checked amazon.nl, which is where I saw the high prices. Looking on tweakers.net now and I see megekko.nl has it for 259 euro. I am going to pick one of these up and see if it works...

Ah, thank you... I thought you only had to match the RAM in each RAM lane 1 and 2. That makes more sense now why 2x16gb kit is $135 and 4x16gb kit is $700.

I have a brand new MSI MPG B550 Gaming Plus motherboard, which is working great, except for the fact I can't get it to register more than 32GB of RAM. It should support up to 64GB. I have 2x 16GB Corsair (https://www.amazon.nl/dp/B01CYILUB8/) sticks which work great in DIMMA2/DIMMB2 and show up...