Recent content by Lucas Swordsen

Alright, that makes sense. There's probably not a way to fix it right? Is buying new RAM the best thing to do right now?

So I built a new pc (specs will be down below) and it seemed to be working just fine. However when under load (gaming) I would either get a black screen and the pc would become unresponsive OR I would get a blue screen which said something about a service system error and a kernel error. Tried...

So I tried reinstalling windows on a completely other drive. The Windows Media Creation tool would do its thing, but then wouldn't boot from the newly made Windows drive. When trying to repair that said drive, it would instantly shut down again after clicking 'Startup Repair'. Switching PCI-E...

Alright so I built it outside of the case. No changes. I also checked to see what would happen if I removed my windows drive and just check if the changes would work. Same result. All that's left to check out now is the GPU and the CPU. One of them must be messing with the memory somehow...

Alright it's fine according to hotaru.hino. I'm going to continue building it outside of the case.

Alright thank you.

New development. As I was taking the pc apart, I noticed something strange: As seen in the photo, there is something missing in the 24-pin cable, an entire cable to be precise. This could explain why I'm not getting enough power which would explain why it can't run at higher voltages. However...

It didn't work. Still getting the same results. Even at 2133mhz, which is what it is on when I set it to 'Auto'.

Yeah I installed them from the Asus website and they are specific to the Tuf B450 Pro. I think I'm going to install it outside of my case. The last thing I can think of now is that my case is shorting something on the back of my motherboard. The case and the GPU are the only things that were...

After some research on what it could be I thought it would be the power supply too. So I bought a new one, a Seasonic 550w bronze +. However, I got the same results, so it must not have been the power supply. You seem to have knowledge about electricity, do you think that the case might be the...

No the replacement motherboard was installed 2 days ago. I thought it might be the motherboard, that's why I replaced it. Crashing only started to happen after I bought a new monitor 2-3 weeks ago. But since that honestly cannot be the cause it didn't seem worthy to mention. Nevertheless I...

Well I can try to do that again. Only problem is that at the moment it's already crashing under extremely small loads at 2133mhz. So the problem has gotten even worse. I revert all changes I make that don't work, so I don't even know how it got worse. But I'm going to try 2933mhz and see what...

No this build has been upgraded over the years. Original system was build around 2 years ago. The RAM is a year old. So it has been working fine with this RAM for more than a year now. It was always running at XMP settings so 3200mhz at 1.35V. Then crashes started out of nowhere when under load...

Small update: slight volt increments didn't work. Also, pc now shuts down after like 10 seconds when doing pretty much anything. I was monitoring my Temps again in HW monitor and then it shuts down. Is my case perhaps shorting the motherboard, perhaps specifically the part that controls memory...

Let's say I do buy a kit listed on the QVL. This problem didn't occur because I changed something. It started crashing out of nowhere and I still don't know why. I'm not really convinced that it will fix anything. I'm still not even sure if it is the RAM, I just don't know what else it can be...