Recent content by MAC262

Thanks, this has been really useful and greatly appreciated. Just one more question (sorry!) should it work normally if i use the commander pro.

I have one Corsair LL120 RGB 120mm Dual Light Loop PWM RGB Fans and three CORSAIR SP RGB ELITE 120mm fans -

Sorry if i sounded like i did not believe you, i am just trying to understand why the RGB cable on my Corsair fans look like the picture in my original post. Is it because it is designed to go into an RGB hub which then has the standard 12volt 4 pin connector???

Thanks, i didn't see that.

Thanks I will get that. Although it does come with a cable and it is shown above.

Apologies you are totally correct.

my motherboard is MSI X670E Carbon Max Wifi and my RGB hub is just the Corsair RGB LED Hub Controller - here is the link to it https://www.amazon.co.uk/Case-Acc-Corsair-RGB-Fan-Noir/dp/B075GWMJ68

Hi I am currently building my first PC but am quite confused by RGB fans. On my motherboard my JRGB header is a 4 pin connecter but the cable from my rgb hub is only a 3 pin connector. Where/how should i plug it in and should i even be using an RGB hub...? - i have 4 rgb fans, 1 is a Corsair...

T Thanks will try that if i ever use that port in the future. (think im going to use the JUSB2 port for now.)

if i use JUSB2 will all my usb ports work? (Damage to JUSB3 above)

why does my motherboard have two headers as i only have one usb 3 cable

Should i test the JUSB3 or just be safe and use JUSB2 (as i dont want my PC to short out)

I was trying to plug in the USB 3 cable into the JUSB3 port on my motherboard

Hi I am currently building my first PC when i accidentaly bent two pins on my motherboard. I was stupid enough to try and bend the top one back into place and it broke off. I think i managed to bend the bottom cable back into place as I tried to plug the cable back in and it goes in fine. After...