Recent content by Mattco00

It worked!!!! Thank you so much! Now I'm in UEFI intead of legacy!

Sure thing, I think the problem was that I cloned the windows from a MBR drive to a GTP drive without any changes being made, therfore I couldn't boot from it. On top of that the bios was crap and had to try the same thing over and over. Now I formated my new M.2 drive again. I might try to...

So this is where I am with the problem: I updated the bios like 6 times and now I got these command lines where I input the "code" : FS0: Flash.nsh Than disabled secure boot and enabled CSM UEFI Devices bellow that. I exited and saved and now it stayed and I booted right into my windows on my...

So If I recreate the bootloader in a different computer and than reseat the M.2 it should show up as bootable?

That might be the problem because I used MiniTool partition Wizzard to convert MBR to GTP.

Okay thank you:) I'm now flashing the BIOS, than try fo enable CSM and I hope it works, if not I will chek my M.2 in an another computer if Its GTP or not.

The new m.2 is GTP with the cloned windows and I have my old SATA whis is MBR with windows too. What I don't really understand is why my drives only showing up when I enabled CSM. Shouldn't they appear when secure boot on and CSM off? I will try to flash the bios as you said nad see if CSM stays...

Yes I did, but the default settings are secure boot on and CSM off:( I read someting about MBR and GTP particion format but I think I set my SSD to GTP which should work, but its clearly not showing as a bootable device.

I cloned my windows to a m.2 ssd from my Sata, and I could boot into windows just fine but then i enabled secure boot (I wanted to upgrade to windows 11) and that desabled CSM support. Without CSM support my drives can't be seen on the bootable options tab in my bios. I tryed turning CSM back on...