Recent content by MushkinSean

Lots of the DDR3 dual memory kits are rated at 1.85V - 1.95V. The sticker on the ram will tell you what the ram is rated for, timings, frequency and voltage. AM3 is fine with these higher voltages

badaxe2, First thing I would do is use MemTest 2.11, it's more up to date and is the preferred MemTest http://www.memtest.org/ Have you tried more Front Side Bus and MCH voltage? Have you lowered to memory divider to 667?

It's more likely to be the board than the CPU TBH. Check to make sure there are no bent/broken pins in the CPU socket. On occasion a bad CPU cooler mount or too tight, in the case of water cooling, will cause weird results.

Hi, You can run four sticks, you will likely have to give up some memory speed, 2T CMD rate for sure. Depends on how cranky your Opty gets. Biggest problem is going to be finding DDR ram like you said. Hit me up on the Mushkin forum, I'll check to see if we can match you up with anything...

Hi, What do you have the QPI/DRAM voltage set to? Should be 1.2V - 1.25V for 1333MHz Did you test the ram with MemTest to make sure all of it is 100% ? If you install three modules does the BIOS and CPU-Z see all three of them?