Recent content by NeatOman

  1. N

    News 3D Benchy’s new owner ruffles the community’s feathers

    The Benchy was good for its time but now it's just to see how fast you can print it. This makes me want to make a "not a benchy" lol
  2. N

    News Intel continues search for source of Core i9 chip crashes — issues statement about recommended BIOS settings to board partners

    "Intel continues search for source of Core i9" ... insert Taylor Swift lyrics.. It's me, hi, I'm the problem, it's me 😅
  3. N

    News AMD lifts memory overclocking limitations on RX 7900 GRE — new Adrenalin driver increases limit to 3,000 MHz

    🤞here's for hoping they lift OC limit on the 6800 non-xt🤞
  4. N

    News Bambu Lab A1 Recall: Company asks owners to turn off their 3D printers as Micro Center pulls product from shelves

    Well, at least it's been out for more than a year and the few flaws have already been corrected and where not fatal flaws (literally in this case)
  5. N

    News Bambu Lab issues A1 Printer heat bed recall: Here’s how to get a free replacement part

    I've always been weary of AC mains to directly heat the bed. It faster and will warp the bed, although that's not as big an issue with bed mesh leveling. But the imagine immediately reminded me of iPhone chargers that always have to hard transition from thick to thin where the cable always...
  6. N

    News Seagate Launches 2nd Gen Dual-Actuator HDDs: 18TB at 554 MBps

    That's still Massively better than it was before when they had to draw there warranties back to just a year o_O this was around the 2010's and WD went though a similar quality phase, but not nearly as bad imo. But going from over 10% on AVERAGE to about 2% is "good". But you're right, in...
  7. N

    News Nvidia Reveals Ada Lovelace GPU Secrets: Extreme Transistor Counts at High Clocks

    Nvidia; 🙈 🤑 🙈 Long->Short; guess where going to have to take them apart and clean them with an Ultra Sonic machine before using them 😡 Nvidia has some pretty aggressive and creative ways to keep there prices up. My (total) guess is there's some type of backroom benefit to flooding a small part...
  8. N

    News Intel Core i7 13700T Raptor Lake Allegedly Beats Ryzen 7 5800X at 35W

    I have a i5-1035G4 (15w TDP) in my laptop that is "configurable" up to 25w, yet also runs at 35w regularly when in performance mode (HP Spectre x360 13"). It definitely gets toasty enough that I tore it down to upgrade the thermal paste, almost put liquid metal but then that would make it run at...
  9. N

    News Don't Buy a Graphics Card for More than $500 Right Now

    I was itching for a new GPU, but I think prices are still about $150 higher than they should be in the mid range. I might buy a used 6700 XT for $325 on ebay, but I really think i should wait for the 7000 series to drop and hopefully prices on older supplies drop like a rock :hearteyes:
  10. N

    News Seagate's Mach.2 Technology Doubles HDD Performance, Microsoft Jumps Aboard

    Would be nice if there is a RAID controller built into the drive when/if this goes to consumers. But maybe one step at a time. Still much cheaper than two 8TB $1500 SSDs vs tiered SSD and HDD if you don't need the SSD performance that much. Double the HDD performance per rack is much more than...
  11. N

    AMD Details Lower-Power Ryzen 2400GE, 2200GE

    Might have found something to replace my ageing i5-661 HTPC, even the stock intel fan is starting to wear out :-/
  12. N

    Question about Liquid Ultra Thermal Compound between die and IHS

    I've noticed after about a year there is a drop in performance with Liquid Ultra, but very small and might just be error. But, after two years the equipment is definitely running warmer. This is very evident in my laptop that now runs about the same as with stock thermal paste. I just got...
  13. N

    Help Me, Tom's Guide: 4K or 1440p for My 32-Inch Monitor?

    Are you wanting to jump to 144Hz if you go with a 1440p monitor? and why not a 34" 3440x1440? And i want to add that scaling in Windows isn't nearly as bad as it was on Windows 7. I have a 3200x1800 13" Yoga Pro 2 and have used x2 scaling and it to works great.. except if you have legacy...
  14. N

    Super Talent Project X DDR4-3733 16GB Memory Review

    There needs to be a breakdown of MHz vs CL, again... again :-/ Just seems like everyone always forgets of the relationship between MHz and CL. For example, 2133MHz CL9 ~/= 2400MHz CL10 ~/= 2600MHz CL11 in certain applications and MHz can win over CL in others. Point is, you may NOT see any...
  15. N

    NEC Announces MultiSync EX341R Curved Ultrawide QHD Display

    I was just looking at a 40" 4k (3840x2160) curved (2000R) monitor on eBay for less than $650. Has FreeSync and/or Adaptive Sync, 4:4:4 10-bit and same type of panel, but only 60Hz :-/ Still happy with my AMH A399u, its a 39" 4K monitor with all the same above but no FreeSync and no curve.