Recent content by Rukh83

Anyway, thanks a lot for the help!

Well, I can send back those I had easily so no loss here. Just the hassle.

Ok, I think I have fixed the problem... kind of.

Ages ago, like 10 years ago I had exactly the same issue. That's why they recommend to run memtestx86 on each stick separately. In my case it was an issue of a bad memory though.

I have tried to find the Command Rate setting but it seems that this BIOS on this motherboard doesn't have such setting. It should be on advanced timing control but it is not there... Also I did some reading in the meantime and it seems that this EXPO/XMP is supposed to be an easy way to OC...

No luck. Tried both settings @1.25V and 1.35V and got the same result: no boot. :-(

Hello again. I have tried overclocking manually but it didn't take long actually to the system stop booting. I have tried 5200 + 1.25V and it booted. Then I have tried 5400 + 1.25v, 5400 + 1.30v, 5400 + 1.35v but non of those voltages worked. When 5400mhz is reached system stops booting...

Thanks for the warm welcome :-) I haven't tried that yet. I will try it later when I'll have more time on my hands. You think that the board is not able to support that speed? Memory is installed in slots #2 and #4 as per the instructions, at least I think it is ;-) Memory: Slot #2 Slot #4...

I have finished building my new PC. I am using Corsair CMK32GX5M2D6000Z36 memory + Gigabyte B650M Gaming X AX motherboard. After enabling EXPO profile for memory PC is not booting anymore so it seems setup for those sticks is wrong. Only fix for that is to reset CMOS to get back to defaults...