Recent content by solaxun

So i finally got this damn thing stable, and i noticed when i actually 'shut down', on the reboot it just black screens and sits there until i shut off power supply for a bit then boot again. I was previously just hard rebooting pressing the power button earlier and had no issues, is this a...

well they sure as **** advertise it as an 'overclocking' board. The tools are there, they are just in wierd places with different names. Although i did not see ICH / South bridge voltage or RAM divider.

Let me know how you did it, cause i sure can't. Q6600 Corsair XMS DDR 1333 pc1066 BFG GTX 280 OC

I was able to run at 2.7 past posting, but crashed as soon as running any stress tests. I had to tweak FSB, MCH, and Vcore to fairly high levels to even get this far. It sure would help if i could find anyone that has a DX48BT2 successfully overclocked to see what they have their settings at.

Well, thats the thing.... i can't find it in the BIOS. The DX48BT2 bios is not real intuitive. It has a screen to manually set the mem speed and timings, but I don't see the divider. I can't get it to post so i can't see if its jacking up the clock on the mem too high, which could be a...

so my VID is 1.325, i just set vcore to 1.2875 (lowest my dx48bt2 would let me go in BIOS, wtf?) Loaded temps are now 50-53ish. However the voltage didnt appear to make more than a few points difference, what really mattered is that my AF7 pro was only kicking in once the cpu got up to its...

i guess a good question to ask to check the voltage concerns would be if lower voltage would really have a significant impact (for me looks like significant = 10-15 degrees) Also if i do sort this out, since my RAM reads 1066 but is rated 1333, when i set the FSB to 333 with 9X for 3.0 cpu, do...

Venom - HSF comes with paste pre-applied and i believe it's mx-1 Ejay - Powersupply is a Coolermaster 650w, i don't remember if RAM was approved but it should be as i checked for all that when i was ordering, plus corsair is a very reputable brand Bobbknight - i went to texas tech when he...

So I just built my first rig, got everything tied away, and decided to move on to OCing. I have read a ton of material on every website imaginable, but i can't seem to figure out why my G0 has temp readings on the high side. When i do small FFT torture test it touches upper 70 but maintains...