Recent content by stuiner

I ran the Samsung Magician and sure enough, my drive did have the version 3 firmware, so it's now updated to the latest verison. I still have to run Memtest and will update with those results as well. Thanks.

Update.... I returned the refurbished 3070 card and decided to try a factory new card. This time, I went for an RTX 4070 because it wasn't much more than the 3070, would use even less power and I knew it would have a warranty. I again double-checked to find no compatibility issues with any other...

Ok. So I think I've ruled out the psu. I was able to get my hands on a 1000W to try out and still had the same issues. I guess I'll either try the DDU driver removal to re install the drivers and/or return this card and put my old gpu back in. I'll update as this progresses. Thanks for all of...

Ok, I'll investigate PSU or see if I can get a buddy to try out this card. Everything I read beforehand stated that a 650W was fine for this card, but maybe that's possible. I checked the event viewer and did find a lot of errors, but I'm not sure what all of that means. At the time of the...

Hello everyone, Before I start, here is my build: CPU: Intel Core i5-12400F CPU cooler: stock fan that came with the processor Motherboard: Asus Prime H670-Plus D4 Ram: 2x8GB T-Force DDR4 3600 SSD/HDD: Samsung 980 Pro SSD (1TB)/ MSI Spatium 2TB SSD/ original HDD as well GPU: EVGA GeForce...

Great info in that chart, thank you.

CPU: Intel Core i5-12400F CPU cooler: stock fan that came with the processor Motherboard: Asus Prime H670-Plus D4 Ram: 2x8GB T-Force DDR4 3600 SSD/HDD: Samsung 980 Pro SSD (1TB) GPU: Gigabyte GeForce GTX 1070 PSU: 600 W Corsair CX (purchased w/PC in 2014) Chassis: Digital Storm Vanquish II OS...

Hey everyone, I'm looking for some advice on my pc setup. I upgraded my hard drive, motherboard, processor and RAM a couple of years ago and I'm now finally considering upgrading my GPU in the near future. As of now, I'm running an Intel Core i5-12400F processor with a GeForce GTX 1070 gpu and...