Recent content by syntheman

Got the computer up and running. But I have a lot of other things to deal with, like bios, OS, setting up SSD, chipset drivers settings etc. I'll be posting about this other stuff. Thanks

Both of the PSU connectors do fit the Mbrd connector. I'll just use the M one like you say. Looks like I might be firing this baby up in the next few days. Thanks

I think either connector will work. I could check both connectors after powering up the computer. Then I could check the voltage on both connectors. Should be 12 volt measured from the yellow hot, and black negative correct? It's a Antec neo eco 620C. Micro ATX motherboard. Maybe that is what...

I have an A88XM-A motherboard with ATX12V socket. I normally have used a PSU with the ATX12V connector that plugs in the motherboard on other computers I've worked on. Never had to deal with this set up before. This is where I found the hybrid info from the Antec site...

So I'll go for the yellow slots. Then maybe in the future I can use the other slots. Yes I'll be careful on the soldering. I'll just solder the speaker to an old terminal harness that will plug into the speaker pins coming off the motherboard. I'll put some heat shrink over the bare terminals on...

I have built a desktop system about 9 years ago. I'm trying it again. But have some questions. I have been reading a fair amount on this forum. I have tried finding info here, and online searching, and don't see anything that makes it clear. I am trying to figure out ram install orientation. I...