Recent content by troublemecca

It's weird too.... Any time I try a bclkhigher than 105 but less than 125 the system won't even boot...Gets to POST and then shuts off... had to clear cmos a few times before I gave up

... I recently added this as a second drive in my new rig... it gets recognised just fine, however the old Dell restore partition (10GB) just wont quit... i've tried the disk manager, i've tried diskpart from the command prompt (though my experience is limited to following instructions), but...

I'm running stable @ 4.5Ghz... 43 multiplier w. 105 bclk... 1.21v... it idles in the 30Cs and maxes at about 75C... maybe i can get more out of it, but it hangs any time i try 4.6, in whatever combination...

you are able to remove the 3.5" hard drive bays under the mobo, that's the only way

/edit not sure why images wont embed, but here are photobucket links! http://i304.photobucket.com/albums/nn199/troublemecca/IMG_20150416_023803_zpsdrchtwp9.jpg http://i304.photobucket.com/albums/nn199/troublemecca/IMG_20150416_025119_zpsvcovjvx9.jpg...

i thought the throughput was 10Gbits/s...represented by the small 'b'... either way, i ran a storage benchmark and you were right, i am getting 700MBytes/s reads... definitely > SATA3! Thank you, not sure why the software is reading 6Gb/s

Soooo... I ended up getting everything running like so: ASRock Fatal1ty X99m Killer mobo i7-5820k Corsair h100i GTX G. Skills 2133 2x8GB RAM In my enthusiasm I left off the extra fans and haven't put them on at all... so currently running the 2x120mm fans + radiator on top, blowing down onto...

5820k ASRock Fatal1ty X99m Killer corsair h100i gtx g. sklls ripjaws 2x8gb RAM MSI GTX 970 Plextor 128GB M.2 SSD c It's built, running like a dream... currently stable, 4,1GHz @ 125MHz bus... max temp so far is 67C running torture on Prime95, and the fans are barely spinning, idling at about...

ASRock Fatal1ty X99m Kiler Intel i7-5820k MSI GTX 970 G.Skills Ripjaws 2x8gb RAM Windows 8.1 Plextor m6e 128GB M.2 PCIe 2x2.... so i bought this stick thinking I was going to be moving at PCIe 2x2 speeds of 10Gb/s... but HWinfo reports i'm doing SATA3 speeds of 6Gb/s? I'm aware of conflicts...

I just received my v21 in the mail, and it seems cavernous given its square design... Lots of air to move, but there are many options for configuration. In addition to the 200mm front Intake, I plan a 120mm side intake by my graphics card... Along with my h100i's dual-120mm-fan top mounted...

I just received my thermaltake v21 in the post, came here looking for ideas on airflow...I'll post some shots once the rest of the build gets here in a few days.