Recent content by w_willgress

I think that the problem is like the previous posts say that your 6970 are too close together , although your case is very GOOD at keeping things cool and is actually quite well known for its great airflow.

Best answer selected by w_willgress.

OK Found the answer on the of all places the silverstone website. Apparently on the ft02 page under q&a the question of refitting to usb 3.0 is asked and answered with full diagram and install info.. part number G11303260 go figure... Thanks for the help though

I saw this review as well which made me wonder where he got that from I have not seen anything like it. I will keep looking, will post back if i find anything...

I am getting an ASUS P8Z68 Deluxe mobo which has a usb 3.0 20 pin header and ports on the rear i/o .. so my question is can i refit the existing usb 2.0 on the case, to be usb 3.0. I am guessing there should be parts available for this purpose.

Hello, I am hoping that some one could help me refit the case usb 2.0 to usb 3.0

With that cpu I would go for an x58 mobo but that is just my two cents. Everything else looks great although I have been told if you want to SLI in particular you would want a larger PSU like 800-850 at a minimum so if that is a consideration(upgrading in future to SLI) them that doubly...

Have the same mobo and cpu set up was just curious have you had any luck with your creative software suite installing ? I install it but says there are no supported devices... sorry for the side track. I would system restore to a point before installing windows update and driver and see how...

Best answer selected by w_willgress.

Thank-you!! was looking and reading everywhere but was getting mixed results and opinions... Tom's Hardware = awesome

Best answer selected by w_willgress.

Just the first question really, One or two crossfire connectors and why?

interesting... http://www.displayport.org/consumer/ http://www.displayport.org/cms/?q=content/displayport-makes-high-performance-standard

Okay D-sub means D-subminiature AKA VGA cable that has a lesser resolution than the DVI but what about display port?? I assume that because there is only one and because of slighty higher specs it might need only one connector to display full resolution?? Of course trial and error will be...

Okay a few questions, 1) while running these 5870 in CF attach both CF cables yes or no? and reasons why.. 2) Display port resolution vs DVI resolution on dell u2711, it says the I need to use a dual DVI cable to get maximum resolution on the monitor. Does that mean i owuld also have to use...