Recent content by windsley.dave

will the cpu fail anyhow for this case? im afraid my cpu, also is faulty. but the chance is very low.

got the same problem, but no beeep. yours has beeps, so motherboard is not the issue, have you tried updated bios? PSU problem normally doesnt start the system at all or will just start for a few moment and shuts down moments later.

i’ve been following this thread coz i got the same problem with the asrock b550m steel legend. Soooo... motherboard’s the problem afterall??

Got my new b550m steel legend from asrock following the release of zen3 which i have bought, ryzen 5 5600x. Got it booted up normally and worked fine for only 3 days. This morning i tried to boot it up but nothing good. CPU and DRAM error code flashing. Tried to reset bios and cmos with jumper...

lastly, before i rma the motherboard, do you personally think it’s the motherboard or do you think other component may cause this? the cpu? ram? psu? thank you very much for your help!

well, i have used the system fine within 2 days, and it has shown bios update successful on .52 bios. for the power button, i have tried using screwdriver replacing the button, still the same. could the motherboard faulty affect this??

replaced the battery, same issues. removed the new battery, jumped the pins, pressed the clear cmos button( all without any source of electricity, rgb off) same issues, rgb on motherboard lights, no beeps, no display, same error codes. so... rip motherboard? do you have any idea why power button...

consider if the cmos battery was the problem, would replacing it fix the problem? what exactly this batter does? doesnt it only control time on windows? (i have never read this before, explanation would be very thankful). what about the reset cmos button that is included in the motherboard...

i just got this board when ryzen zen3 realeased. literally got here only 3 days ago. assuming the retailer has this board stocked for months, are you sure that might be the problem? should i just rma the board?

just got my new pc working after 1 day of tweaking new bios for b550 for ryzen 5 5600x. chronology before i got the system working : inserted ryzen 5 5600x in b550m steel legend without hooking up bootable device and gpu. beeped 3 times, showing error code of boot and vga. Then connect my ssd...

i could have done that if i were able to get into bios. the system is not able to display, i have tried resetting cmos by removing the battery, jumping the cmos, and by using the clear cmos button. nothing worked. still no display. motherboard beeped 3 times when it came brand new when using...

thanks! for the welcome and for the qucik response. have tried the usual A2 and B2 slots which got the system booted for 2 days before it stopped, and have also tried only 1 stick in A1 and A2. nothing worked, ram only lights up no beep code, error code dram and cpu. have used this psu for...

just got my new pc working after 1 day of tweaking new bios for b550 for ryzen 5 5600x specs: Cpu : ryzen 5 5600x stock motherboard : asrock b550m steel legend ram : 2x8gb 3600mhz corsair rgb pro psu : corsair tx750m gpu : gigabyte g1 gaming gtx 1080 i have just changed my whole system except...