Recent content by wowgamer97

I've got a corsair tx650 psu and the fan isn't running. But I've got power.... I've read that the fan doesn't kick on until 350 watts are reached. It does turn on on start up but then turns off. Do you think this is normal? .... and if I'm running that low wattage do you think it's ok to...

yup the msi disk is behind the board and barely visible in box and I missed it, download drivers and everything is fine. thanks.

I just put my system together I have an asrock z77 extreme4 with a msi gtx 570 gpu win7 ... I've got the gpu hooked up correctly in the pcie2 slot. It's got power to it and the monitor is hooked up to it and the monitor is on and the fans are running but it's not on my display adapters? Any...

ok never mind I got it to work... I didn't realize I had to hit the key during the start up to get into bios.

I've just put my rig together and I'm trying to boot it up, I've got a Razer Black Widow and it's not coming on.... any idea's.

ahh ok thanks

yes sorry cpu

Ok I've got my pc up and running.... I've run into a little snag My Razor Black Widow isn't coming on and my Dell u2412m is entering to power save mode upon boot up Any suggestions? p.s. I haven't gotten through post because my monitor won't work

my question though was that I have 2 extra 3pin "PCU" fan sockets that I'm not using because my pcu is using the 4pin socket..... so If I use these for the case fans i have enough connectors. Will it matter if i hook my case fans up to the pcu fan connectors on my mother board?

I have 3 3pin case fans in the Antec Nine hundred and I only have room for 2 on my mb.

I was looking at the wrong schematic/board.... the extreme4 comes with 2 3pin chassis fan connectors and 1 pcu 3pin connector. So my question now is can i use the 1 pcu 3pin connector for one of my fans if I'm going to use the 4pin connector for my pcu fan? Thanks.

I'm getting my parts in today... From what I can tell online, the ASRock Z77 extreme4 board I'm getting only has 2 - 3pin fan connectors. One on the top of the board as a PCU 3pin connector. I'm assuming I can use that as a fan connector because I'll be using the 4pin connecter right beside it...

Putting my New Rig together, should I invest in AVG or should I just stick with MSE? I play Wow so I'm kinda hesitant to use AVG.

Thanks again! :)