Recent content by xmark06x

When I increase it by +0.05 to 0.898v the number turns red. Is that a warning not to go that high or just a precaution and it is safe to operate at that voltage? edit: I realised after i wrote this that you meant change the offset mode to + and change the voltage offset to 0.05. I tried this...

I don't see DDRVTT or CPUVTT. I have included an imgur link of bios screenshots and would appreciate if someone could tell me what I need to raise for the memory controller. I see VCCIN and had read it was the amount of power sent from the motherboard to the processor. Is that the only thing...

@13th monkey, I think you might be right. I did a quick search and found this: "The Intel Haswell microprocessors are only rated to dual-channel DDR3-1600, and this is what they are tested for. However, it is possible to exceed this if you're willing to make a few sacrifices. Some...

"the memory controller on your CPU is also being OC'd at this point, so that might be the cause". I am not sure what this means. :/

Thanks for your suggestions. The ram worked fine at default 1600mhz, never had a problem so I don't think the ram is faulty, I assumed it was something I was doing wrong in the bios. (I'm not in any way an expert) I will try memtest86+ someday when I have time. The motherboard supports up to...

I am trying to get my ram to the speed it is supposed to be at. I have Gskill Ripjaws 2133mhz and they default at 1600. 4 x 4gb. I was reading up on how to do it and it said to use the xmp profile in the bios, my bios has 2 xmp profiles but when I select either I am getting random crashes. I...