Recent content by xnick101

Any suggestions on good led fans that aren't going to be $200 for 6 of them? Corsair LL120 would be my choice but I don't see any reason to spend $200 on just fans. These cost me $45 and work really well.

Yeah, there's about 5 feet between the wall and the side of the PC.

I brought the temps down a lot by putting the fan curve to normal instead of quiet on L-Connect 3 but more importantly, the biggest drop I saw was changing a setting in windows power settings. Changing the minimum processor state to 10% instead of 100% which is what it is set to under the AMD...

share image The side panel where the wiring is??

Lian Li Dynamic. Only the Dynamic XL can fit a rear 120mm fan.

I had my fans on quiet mode in L Connect. I put the fan curve to normal and now it's getting closer to 40 C. But I will try testing having the radiator on the side

Suggestions for backup?

Update: I GOT IT WORKING!!! I was going to try cutting off the plastic piece on a spare HDD I had and I was going to glue it on and try that. I ordered a SATA to USB connector because it would be easier to test if it's working from the USB rather than rebooting the PC every time to check...

So when you say have the radiator fans as intake, it would go on top and the radiator would go below the fans, right? Because currently the radiator is on top and the fans are below it blow air up into the radiator.

From some videos, I've seen with testing this is the best way to set up a lian li dynamic series case. Because there are not front or rear fans. The fans are on top, side, and bottom.

How can I exhaust out more of the warm air then? Apparently, 9 fans are not enough haha.

Do my CPU temps seem high? The current room temp is 25-26C. I have a Lian li Galahad 360mm AIO and my temps are somehow worse than they were when I had an air cooler. The current temps in the picture are after 1 hour of playing call of duty but sitting on the desktop with the game closed now. I...

I will try that! Thanks!

The guide is stuck inside the SATA cable. That plastic is super cheap. I tried to get it out with a small flathead and the plastic started just falling apart. Although I found a few videos where put cut the guide off of old HDDs and stuck it into the sata port and plugged it in. Sometimes it works.

Thanks for the recommendation. Yeah, I went to a few local computer repair shops today and none of them could solder. It was a surprise to me.