Recent content by xxMJTxx

Thank you all. I get some ideas now. I stick with geforce for many years, but what's the difference between ATI? game compatible?

for game. That's why I am looking for dx11 support card. I keep looking at internet, I know Geforce 400/500 series support dx11. But I am not quite sure which model should be the good one. Is that all 400 series above support dx11? I am not quite sure though. Thanks.

Hello, I am thinking to upgrade my display card for a while, but I still doesn't have any clues yet. I am using Geforce 9800 GTX now and I am very satisfy with it. "DX11" is the only reason to make me think about that. Could anyone give me some ideas of which card I should look at it? I don't...

I found that someone talked about the same case of gigabyte board in the past. This is exactly of my solution, the single ram module only work on one slot. if seat two ram, only two slot works but no dual channel. This is the motherboard ram slot issue on gigabyte board...

Yes, got paste and I just clean it up, place new paste, reseat heatsink and fan during to figure out the problem. Thanks for the advise!

ok, I think I found the problem. I had the ram on slot 1&2 before. I tired to put a single module on slot 1 or 3, it gives me continues short beep sound. When I put it on slot 4, it works again, then I play around with different slot for two rams. On slot 2 & 4, it works charm. Thank you for all...

I just tired to boot with onboard display connected to monitor. Doesn't work, still boot up for few seconds and then shut down, keep looping. I am wondering is that the PSU problem. I thought it was overheat before, but I checked the log of CPU temperature, it was just around 28-40 degree. I...

I also tried to put on top of cardboard because I saw someone suggest this, but doesn't work. And I just checked all the post are fine even on the back. Btw, I am leaving everything unplugged again right now and see what happened tomorrow morning.

Hello all, my new computer was setup on 3 months ago, It suddenly shut down yesterday and I wasn't able to boot up. I tried to many combinations, but still the same. I took out the CMOS battery, unplugged everything even the power supply and left it for over night. The other day, it works again...