Recent content by Zakya

Sorry, this might be the wrong place to post this, but this was a close to a meta-subforum as I could find. I was using google and clicked on a link about gpus. It seemed familiar, as I had just seen the same arctile here. I compared them, and the articles have the same structure, but look like...

Wouldn't watercooling be as bad for vrms?

Also looking at the logs almost always when it drops the last warning is VRTEMP

In the logs they hit 130C. Probably gonna put an arctic p12 max in the psu and add a heatsink to the vrms

Well that would just leave performance on the table. This happens basicly only with Primd95

I'm on win 10

I ran cinebench for 30 minutes and y-cruncher for a bit after undevolting 100mV and making it so that it lovers voltage more easily. Also made PL1 90W. Now one core might just throttle for a second in the initial turbo and then it runs stable at 91C. This beahviour didnt show up on either of the...

Could I also just somehow limit that if its over 85C, don't go to PL2 for a bit

It seemed to start doing it instantly on prime95 now

It does. I can draw about 150W while turboing in the start. Then it runs like 7 minutes just fine at 100W and then the weird behaviour starts

Am using a thermalright axp-90 x53 full black. Best i could fins for under 54mm. I do not mind it throttling down a bit after 9 minutes, but i wouldn't like it to instantly boost back up again every 5 seconds. I have somehow managed to kinda oc it in bios even though it is a non-k. PL1 should be...

Greatwall is an OEM brand. They make or atleast made corsair's power supplys. The psu came with the case. It works as an intake and has a reversed fan. It also has shortened cables. I have a 3060 ti and 4 dimms in an 8L case, so that is kind of a nescesity. Newegg suggest a 500-599W psu for my...

Hits 100 a bit before 10 minutes in a stress test, but both PLs are over stock. I wouldn't mind it throttling down a bit, but the square-ish waves don't look too sustainable. Stock about 40 C. Shown in the pic

edited edited

I have a 13500 in a b660. When I run a stresstest after about 9 minutes it starts frantically switching between PL2 and then back to PL1 when it instantly throttles. Or atleast it goes like 10W over PL1. How can I fix this? PL1 is 100W and PL2 is 154W. I am using an asrock deskmeet b660. The psu...