argb fans

Hey guys, I wanted to connect all my RGB components either to my motherboard or my Cooler Master controller to sync it all but the RGB fans on my case don't have the typical RGB fan connector, instead they have this connector shown in the picture. What type of connector is it? And what type of...

[Moderator edit: Changing title to Info and moving thread from Components to Opinions and Experiences. Post is not a technical question and based on OP's experiences.] My new setup is the microcenter MSI B650-P Pro Wifi and Montech King 95 (non-Pro) case. I bought 4 types of Thermalright...

Hello! I have a plan to set my ARGB fans here and I’d like some opinion/confirmation that it makes sense. First, here’s what I’m using Case: NZXT H6 Flow Mobo: MSI MAG B760M Mortar Wifi II. The JARGB_V2 connectors allow you to connect the ARGB Gen2 and the ARGB-basedLED strips. The JARGB_V2...

Hi everybody, I have a question about the fan controller of this case which I do not know how to connect. Here are some pictures: There are four fans. Each one is conncted to the controller via one of the four connectors on the right, the fan cable continues beyond the fan controller and at...

So recently i bought a new motherboard (msi b550 pro-vdh wifi) and i cant seem to make my two argb fans light up with the msi mystic light software. I have the two fans connected via a coolermaster ARGB splitter cable yo my JRAIBOW1 connector of the motherboard. On my previous one it worked...

So I bought a CyberPowerPC Model C series and wanted to rebuild it's fans on a different tower. There are a total of 3 D-RGB fans and I've managed to daisy chain them together. Problem, when I connect the 3-pin D-RGB (ADD_GEN2) to the MB I don't get lights. I don't know if any of this setup was...

I have to cancel my order before it makes it way to shipping before I get the wrong item. I am looking to connect up to a total of 5 RGB fans (120mm) to take full potential of my ATX computer case. My motherboard is a ROG Strix B350-F Gaming motherboard that has two 4-pins RGB header. So if I...

How do I connect 3 ARGB case fans and one ARGB CPU fan to a motherboard that has no ARGB connectors while still being able to control them through aura sync. Is it even possible? If so what kind of control box will I need?