Hi all,
I've recently built a pc which i was running a stock cooler on until my AIO was delivered.
I removed my stock cooler and cpu and cleaned them to find out the aio i ordered was too big for my case, so i put the stock cooler and cpu back in as normal.
After that, when i tried to boot, everything would start up (fans, lights, etc) but there would be an 0d error code and the monitor wouldnt work.
I googled a couple things and found out it could be an issue with my cpu or motherboard pins being bent. I went and checked the cpu pins and all seemed to be fine and my motherboard has a cover over its pins which makes it hard to see if they were bent.
I tried alot of stuff and eventually the pc booted when i took a stick of ram out.Turns out my computer only boots when there are no ram sticks in the DIMMb slots.
I've tried both tightening and making my cooler looser with no effect.
Im assuming this is still a cpu or motherboard issue and i was wondering if i need to get this checked out in a repair shop.
the cpu pins all looked fine to me but i was just using my eyes with no equipment
Could this be another problem? Or is it probably cpu/motherboard issue?
My Specs:
Msi meg x570 unify mobo
Ryzen 9 3900x cpu
Wraith prism stock cooler
2x 8gb XPG gammix ddr4 3200MHz ram
radeon rx 5700
I've recently built a pc which i was running a stock cooler on until my AIO was delivered.
I removed my stock cooler and cpu and cleaned them to find out the aio i ordered was too big for my case, so i put the stock cooler and cpu back in as normal.
After that, when i tried to boot, everything would start up (fans, lights, etc) but there would be an 0d error code and the monitor wouldnt work.
I googled a couple things and found out it could be an issue with my cpu or motherboard pins being bent. I went and checked the cpu pins and all seemed to be fine and my motherboard has a cover over its pins which makes it hard to see if they were bent.
I tried alot of stuff and eventually the pc booted when i took a stick of ram out.Turns out my computer only boots when there are no ram sticks in the DIMMb slots.
I've tried both tightening and making my cooler looser with no effect.
Im assuming this is still a cpu or motherboard issue and i was wondering if i need to get this checked out in a repair shop.
the cpu pins all looked fine to me but i was just using my eyes with no equipment
Could this be another problem? Or is it probably cpu/motherboard issue?
My Specs:
Msi meg x570 unify mobo
Ryzen 9 3900x cpu
Wraith prism stock cooler
2x 8gb XPG gammix ddr4 3200MHz ram
radeon rx 5700