2 molex to 6pins currently power my gtx 670, Would using the 2 6pins from the molex to power an 8 pin power my 1070?

[Christian_97]

so basically, the connection goes from
4x molex > 2x 6pin(powered by 2x molex each) > 1x 8pin(powered by 2x 6pin)

 

[DSzymborski]

Without knowing your PSU, I'm not even sure if what you're doing is safe *now*.

 

[Christian_97]

Without knowing your PSU, I'm not even sure if what you're doing is safe *now*.

This is my psu https://www.amazon.com/Cooler-Master-Silent-Pro-RS600-AMBAD3-US/dp/B001NJ0CYG?th=1 I lost the cables for the pcie so ive been running my palit jetstream 670 with it through 4 molex connectors to 2 6pins. From my understanding the 670 uses 185W under load, whilst the 1070 uses 150W. Am I correct to assume my suggested set up will power the 1070?

 

[Wolfshadw]

In theory, yes. It would work. In reality, you're risking a $400 graphics card on essentially a hot wire job. Do yourself a favor. If you can afford a $400 graphics card, you can afford to repurchase the appropriate cables.

-Wolf sends