Hi all,
I have an ASUS ROG Strix 2080ti that I have installed a waterblock on. My custom loop goes through my CPU and GPU into a 420mm rad.
I have clocked my CPU at 5GHz and my GPU usually clocks at about 2GHz. However, as soon as my GPU reaches about 60c, my monitor goes black, says no signal, but I can still hear and interact with my PC (YouTube, etc). Could it be that I have improperly installed my waterblock (i don't think so as the temp is fine).
So why would my graphics card shut down? I have searched for ages for a bios setting or nvidia one but I can't find anything. Do I need to update my bios or something?
Also, this has only happened recently, and I have cleaned my PC thoroughly, and the problem still persists. Tell me if you need more details!
Thanks so much,
Will
I have an ASUS ROG Strix 2080ti that I have installed a waterblock on. My custom loop goes through my CPU and GPU into a 420mm rad.
I have clocked my CPU at 5GHz and my GPU usually clocks at about 2GHz. However, as soon as my GPU reaches about 60c, my monitor goes black, says no signal, but I can still hear and interact with my PC (YouTube, etc). Could it be that I have improperly installed my waterblock (i don't think so as the temp is fine).
So why would my graphics card shut down? I have searched for ages for a bios setting or nvidia one but I can't find anything. Do I need to update my bios or something?
Also, this has only happened recently, and I have cleaned my PC thoroughly, and the problem still persists. Tell me if you need more details!
Thanks so much,
Will