I have an Inno3D 3090 iChill X4 that is not posting so I connected a Skypro to the ISSI chip on it and I can erase, read and write however the first sector on the chip gets lost.
Does this mean I need to solder on a new bios chip? Any workaround?
I tried to offset by one and no post.
You can see here when I open it has NVGI - >
View attachment 2490406
When I write it changes to a '.'
View attachment 2490407
Confirmed that is the only change to the write -
Any ideas?
Also I cannot seem to find any of these ISSI chips in stock anywhere...
Does this mean I need to solder on a new bios chip? Any workaround?
I tried to offset by one and no post.
You can see here when I open it has NVGI - >
View attachment 2490406
When I write it changes to a '.'
View attachment 2490407
Confirmed that is the only change to the write -
Any ideas?
Also I cannot seem to find any of these ISSI chips in stock anywhere...