775T Socket Foxconn Pin Layout Question

[Grimjow]

Hello all, I have a Foxconn G33M02 mb for the 775t socket. I am putting it into a new case and was wondering if you all could guide me in installation as I have searched videos and found nothing. I know where everything goes except for the small 9 pin rectangular connector on the bottom right hand side of the mb. In the current case the connection to the power supply and reset, led's, etc... is made with a single plug and is not separated, I would like to know the best way to hook up my new reset and the other wires into the mb from the new case as it will have separate wire plugs and may not fit into the small 9 pin plug. Any guidance or links to other posts or preferably video's is most welcome.

 

[WyomingKnott]

There's a map of the front panel connector pins at the end of this very sparse document: http://www.foxconnchannel.com/driverdownload/Motherboard/Intel/Socket775/G33M/manual/Easy%20Guide/%283A2505E00-000-G%29-G33M_easyguide.pdf

Then read the manual for the new case and find out which leads correspond to those pairs of pins. Good luck.

 

[Grimjow]

That's great tyvm. Is the pwr led for your power on off switch? and the hd led for your lights and gizmos etcc..?

 

[WyomingKnott]

Nope. "PWR SW" is short for Power Switch, and goes to your on/off switch.
"PWR LED" is the Power LED, which goes to the case light that lights up when power is on.
"HD LED" is the Hard Drive LED, which goes to the case light that lights up when there is activity on your hard drive.
"RESET" is for the case's front-panel reset switch. I consider this too dangerous to exist, and I don't connect it when I build a machine.

Don't use any of these for decorative lighting or pumps or other gizmos.