8 pin 12V Cpu connector too hot

[ANIL YALCIN]

Hello TH.

As i write, my psu's 8pin 12V connector cable too hot, its burned my old motherboard (GA 990 XA UD3 Rev3.0) and i have now ASUS M5A97 R2.0

my psu CM-RS ACAB M2

what can i do please help me.

 

[Dark Lord of Tech]

It's a very poor cooler master power supply , the only good Cooler Masters are the V series.

 

[ANIL YALCIN]

I have other 2 power supplies but they have too low wattage. One is 300W, the other one 350W

 

[ANIL YALCIN]

I have old 750W Thermaltake PSU. don't remember model, it was burned i think. it was blown fuse. and the other one 550W psu has exploded. i think its transistor or capacitor.

My old mobo's 8pin connector has melted cause PSU. I don't wanna more problem. plz help me

 

[Dark Lord of Tech]

You need to get a first rate PSU to protect your componets.

 

[ANIL YALCIN]

It's a very poor cooler master power supply , the only good Cooler Masters are the V series.

You need to get a first rate PSU to protect your componets.

i don't have too much money novadays but i don't wanna burn them all

I have this components now

ASUS M5A97 R2.0
AMD FX-6300
ASUS GTX660 TI DIRECT CU-II


is that psu enough for me?
http://i.hizliresim.com/LQyNvo.jpg

As i remembered, it wasn't too hot old days. now every power supply has same reaction

 

[Dark Lord of Tech]

http://www.teknobiyotik.com/seasonic-s12ii-80-plus-bronze-620w-aktif-pfc-guc-kaynagi.html
This is quality , built to last.

 

[ANIL YALCIN]

http://www.teknobiyotik.com/seasonic-s12ii-80-plus-bronze-620w-aktif-pfc-guc-kaynagi.html
This is quality , built to last.

i sent the link does not work?

 

[Dark Lord of Tech]

The link I posted does work.

 

[ANIL YALCIN]

The link I posted does work.

im asking for it can you look for this

 

[ANIL YALCIN]

The link I posted does work.

or this

 

[BFG-9000]

The connector melted because it had too much resistance--hence why it got hot. Replacing only the motherboard side may not fix the problem but replacing both sides will for sure.

If you have no warranty left on the CM just cut a good EPS12v plug off one of your dead power supplies and splice it onto the CM. Then you can use it safely until you get a better power supply.