Add VLAN to Ubiquiti router and Netgear switch. Dont get IP from VLAN50 interface DHCP.

[jojo82]

VLAN implementation issues..

- Ubiquiti router (1.8 firmware)
- Netgear GS108Ev3 switch. (latest firmware)

Port 8 is my trunk/tagged port
Port 2 is my accessport/untagged port
Port 1 is my management port

Have setup VLAN 50 along with a DHCP server in my Ubiquiti router. (See screenshots) and added VLAN 50 to the Netgear GS108Ev3 switch. When I put the cable in port 2 I loose the connection to the switch, if I put it in port 1 i gain access to the switch web interface again. I never get the DHCP adress from VLAN50 DHCP, not even if I disable the network adapter, or release/renew.

http://uploadpie.com/SDPzo

When trying to remove vlan1 I am getting this:
http://uploadpie.com/tNl1G

Anyone can figure out how to get this VLAN working so I get an IP from the VLAN50 dhcp?

 

[bill001g]

Hard to say you have defined port 2 and all your other ports as trunk ports. I suspect you would have to remove vlan 1 from port 2 to make it a actual untagged port on vlan 50.

 

[jojo82]

added vlan 50 as pvid on the accessport, and restarted the network adapter and waited for like 3-4 min before it got connection and a dhcp adress again..