Adding GPU to Pre-built HP Elite 8200 CMT

[dragonbane47]

Will a 1050 ti ssc gaming acx 3.0 fit into a pre-built HP elite 8200 CMT (Minitower not SFF) and does it have a 6 pin power connector or does it draw all the power from the pci x16 slot? And if it doesn't fit will the single fan 1050 ti work just as good (I know that the single fan should fit)
I ask this because the bigger card is 20-30 dollars cheaper than single fan.

 

[Kasper Jorgensen]

If it have a 6 pin connector will depend on the exact GPU you buy. Just look up the specs before you buy it. How many watts are the PSU in your rig? You need to make sure it is large enough to drive that GPU.

 

[dragonbane47]

If it have a 6 pin connector will depend on the exact GPU you buy. Just look up the specs before you buy it. How many watts are the PSU in your rig? You need to make sure it is large enough to drive that GPU.

I believe the PSU is 320W which is enough for 1050 ti without a power connector since it only pulls 75 watts

 

[Kasper Jorgensen]

Yes that is enough, yet just barely. Hope it's a good quality PSU as cheap ones don't like being pushed to the limit.
Anyway, some of the cards doesn't require 6pin power, others do, specially those factory overclocked cards.