Air Bubbles in my loop Will not come out after 48 hours

[neverblink]

In my bottom Rad there is a air bubble deposit and only comes out when I tip the computer towards me. At the point the bubbles rush into my pump and does NOT go into my res it goes straight back into my loop collecting elsewhere and mainly back into the bottom rad.

I need guidance. I just flushed the fluid and put it back in. There are no leaks.

my other loop is fine. clear loop is the problem.
Picture

https://imgur.com/gallery/7xa2W

 

[Eximo]

I've found the best way is short bursts when the pump sucks the bubbles through again. Assuming the pump is going full blast. If you have a variable pump run it as weak as it will go and do the same tilting.

 

[neverblink]

Yes, I am already at the lowest setting and have been tilting and power cycling