Antec p180 case with gigabyte ga-z77x-ud3h

[djeuro1981]

Hi I have a Antec p180 case that was just given to me and I have just transferred everything across from old gigabyte case to new case and have noticed there is no power + and - cable to plug on the motherboard there is only power led power sw hdd1 hdd2 reset I have tried plugging everything in as normal and get no power at all on the system

System specs

gigabyte ga-z77x-ud3h motherboard
Core i7 3770k
16gb ram

Please note before I pulled everything from old case everything worked fine no issue at all

Any help greatly appreciated

 

[smorizio]

power led is for the case power led. it the only one other then the hard drive led that has (+) (-) side for the led.
if it not on right the led wont turn on. the power and reset just have to go on the right pins. on the f-Panel header.
pin one and two bottom row left. hard drive led then next to it is reset.
the last three pins for power led.
top row 3-4 pin from left is on switch.

 

[gondo]

Power SW is for the switch to turn the system on. It's not +- since all it does is short the 2 pins to turn it on. The Power LED is +- since it gives DC power to turn on the LED of your case. LEDs are polarity sensitive.

Reset switch is the same. Just shorts the pins to reset the motherboard. So no polarity. All you need to do is take a paperclip or pair of needle nose pliers and short the 2 pins together for a second to turn the system on. The Power SW is the one you are wanting to use.