Hello again!
I have finally bought arctic accelero extreme iii, and I am trying to install it on my gigabyte 1080ti turbo. I am not sure if my heatsink layout is correct, i was helping myself with photos from the internet, and the old cooler. Can I glue every heatsink by using this 3m thermal tape that I have bought? Its very thin compared to normal thermopads :/
And the last question, do I need to use the insulation tape? If Yes, where?
Here are the photos:
https://ibb.co/f4x3Cr6
https://ibb.co/DGB5wL5
This thermal tape properties:
0,05mm thin
Work temperatures: from - 20 to 130 °C
0,17W/mK
I hope you Can help me guys
Edit.
After removing the stock cooler, I have noticed these weird color makrs on pcb, should I be worried about it?
https://ibb.co/1zvPbV9
I have finally bought arctic accelero extreme iii, and I am trying to install it on my gigabyte 1080ti turbo. I am not sure if my heatsink layout is correct, i was helping myself with photos from the internet, and the old cooler. Can I glue every heatsink by using this 3m thermal tape that I have bought? Its very thin compared to normal thermopads :/
And the last question, do I need to use the insulation tape? If Yes, where?
Here are the photos:
https://ibb.co/f4x3Cr6
This thermal tape properties:
0,05mm thin
Work temperatures: from - 20 to 130 °C
0,17W/mK
I hope you Can help me guys
Edit.
After removing the stock cooler, I have noticed these weird color makrs on pcb, should I be worried about it?
https://ibb.co/1zvPbV9
Last edited: