arctic silver adhesive

[califmike2003]

Im a idiot i arctic silver adhesived down a heatsink to my southbridge chip, and its not where i want it, is there anyway to take off arctic silver adhesive ????????? is there a remover for it ?.

 

[spathotan]

Try to twist it, not pushing down or pulling up. You dont want to bend the motherboard. Depending on how much you put it on will determine how hard it will be. They dont say the stuff is permanent for nothing.

 

[JohnnyLucky]

Here you go:

http://www.arcticsilver.com/arcticlean.htm

 

[Conumdrum]

LOL, that stuff is used to clean chips once the HS has been removed.

Two ways to try and get it off. Put it in the freezer for an hour or so and twist it off. Second, use a hair dryer and get it nice and hot and twist again.

Ohh third... Get a can of compressed air, turn it upside down and spray the liquid right on the chip/HS/ bottom of the board. You'll use the can up fast, have gloves ready etc right away, it will be below 0 C for sure. Twist and hope.

 

[bpogdowz]

yeah a can of compressed air should work great

 

[Shadow703793]

Use Alcohol. It will remove it. Had similer case and Alcohol worked.

 

[califmike2003]

Thanks for all your replys guys, i will try this weekend and see if i can get it off with your ideas,

 

[califmike2003]

Wow thanks guys the alcohol works greatttt , was worried it wouldnt come off, i used a eyedropper and put some alcohol around it, and twisted it right off.

 

[Shadow703793]

^See? What did I tell you? Much safer than putting it in a freezer,etc.

 

[Conumdrum]

Really? Excellent. I thought that was like epoxy as the reviews on the AS5 site say and alcohol doesn't break down epoxy at all. But, epoxy on a smooth surface really doesn't hold up well to twisting etc, so I guess with gentle twisting it'll pop off easy enough.

Glad ya got it is what matters.

 

[Shadow703793]

^The Arctic silver is an epoxy BUT the bond is very very weak. If you left the glued object in a container filled with water(~1hr) it still would have come off.

 

[rubix_1011]

Electronic components soaking in water...

In theory, it would work as long as everything dried out (and let's say you used distilled water)...still not something I am willing to risk. Someone dunk their graphics card for a few hours and let me know how it turns out...