I recently built a new system with two older hard drives. These are two Western Digital Raptor 37 GB 10,000 RPM hard drives. They're set up with an AMD Phenom II 940 processor on an Asus M4A79 Deluxe Mother Board. The raid controller is AMD via AMD Fastbuild. I set up the hard drives in Fastbuild with Raid 0. MBR for both hard drives were erased and the raid array was set up. After they were set up, the system reboot, taking me to a screen where it stated the raid array and said "functional". However, the screen just sat there for hours. Thinking the system was frozen, I restarted and the same screen showed up. I couldnt access Fastbuild via the hot keys (ctrl+f) and the screen was just sitting there. I then unplugged one hard drive and rebooted. Fastbuild recognized the one hard drive and then I finally had the option to hit ctrl+f to access the utility. Once in the utility, deleted the array from the one hard drive plugged in. I then plugged the other hard drive in and rebooted and now I get to a screen where it says the raid array is "offline" and I have no option to hit ctrl+f to delete the array this hard drive. Now I literally can't delete, set up or modify the array when this hard drive is plugged regardless if the other hard drive is plugged in or not. I'm constantly routed to a screen where it says raid status "offline", and the system hangs here. Can anyone help?
Thanks
Thanks