First time threader.....
Yesterday i replaced my Pentium 4 CPU and existing hardware for a shiny new P8Z77-V Pro mboard, i5 3570k cpu and g skill trident x 2400 ddr3 16gb kit.
I power up and all my fans start spinning (case fans, Cpu, graphics card, Psu all spin) then i get the red cpu led light and the system resets. It is only on for a couple of seconds.
I have been on the forums chasing up solutions but i am getting nowhere fast:
Checked all power connections including 8 pin atx connector (my psu has a 4 pin)
Checked ram 1 stick at a time in all slots
Reset cmos with cpu in and with it out
Checked cpu if installed correctly
Checked cpu for bent pins
Checked mboard and is installed correctly
I think i am out of ideas. Any new ideas would be appreciated.
Thanks
Yesterday i replaced my Pentium 4 CPU and existing hardware for a shiny new P8Z77-V Pro mboard, i5 3570k cpu and g skill trident x 2400 ddr3 16gb kit.
I power up and all my fans start spinning (case fans, Cpu, graphics card, Psu all spin) then i get the red cpu led light and the system resets. It is only on for a couple of seconds.
I have been on the forums chasing up solutions but i am getting nowhere fast:
Checked all power connections including 8 pin atx connector (my psu has a 4 pin)
Checked ram 1 stick at a time in all slots
Reset cmos with cpu in and with it out
Checked cpu if installed correctly
Checked cpu for bent pins
Checked mboard and is installed correctly
I think i am out of ideas. Any new ideas would be appreciated.
Thanks