ASUS Prime Z270 A No DVI video Signal

[shadowraz]

Hello everyone, i have a little problem with my new PC build I just put together, this is the first PC i ever built so i think i am a little lost.

My build:
Mobo: Asus Prime Z270A
CPU: Intel i7 7700 (No K)
RAM: G Skill 16Gb 3200 Mhz (2x8) (UEFI detect it at 2133Mhz)
PSU: Seasonic M12II EVO 750w

My problem is, after put together the PC started but i had no video signal from the integrated ports of the motherboard, reading the mobo manual I realized that the post stage went fine, but i still had no video signal, reading other similar problems, they recomend to test with a PCI graphics card, so I did it, installed a Asus Nvidia 210 and ia had video signal from the card but no from the mobo (Edit. Until this point I was using the same DVI cable, testing only on the DVI ports), then I changed one option in the UEFI interface. In the advanced mode, in the advanced tab, entered on the system agent config option and change the Primary Display from auto to IGFX, after this I restarted the PC and had video signal from the Mobo but only from the HDMI port, the DVI port still no signal at all.
I want to conect 2 Monitors, one with HDMI and the other with DVI, but DVI has no signal.
It is posible that the DVI port is dead? I have to RMA the mobo ?

Any suggestions will be greatly appreciated.
(sorry for bad english)

 

[DRagor]

Check if the DVI cable you have is good first. If it works with other GPU fine, most likely you have faulty DVI port on motherboard, which would require RMA if you really need to use it.

 

[shadowraz]

Check if the DVI cable you have is good first. If it works with other GPU fine, most likely you have faulty DVI port on motherboard, which would require RMA if you really need to use it.

The cable works fine with the graphics card, so i think it is the integrated port :/