Flip switch on power supply and motherboard lights up, a couple seconds later fans start to spin then immediately stops. Computer will not boot up.
System specs:
-Asus Rampage IV Extreme X79 motherboard Black Edition
-Intel i7 4960X 3.6G 6C 12T 15M S2011
-G.SKILL Trident X Series 32GB (4 x 8GB) 240-Pin DDR3 SDRAM DDR3 2400 (PC3 19200)
-Antec HCP-1300 Platinum 1300W ATX12V / EPS12V
-512GB 2.5 SATA III 840 PRO SERIES INTER SAMSUNG
-NVIDIA QUADRO K5000
-NZXT CASE CA-H630F-M1 H630 FULL TOWER 2
-Noctua NH-D14 SE2011 140mm and 120mm SSO CPU Cooler
Troubleshooting tried:
Unplugged everything from motherboard,
just CPU and power supply -same
one ram stick in primary memory slot -same
just 24 pin power connector on motherboard connected -same
used different power supply and connected 24pin on motherboard -same
connected CPU fan, 24pin PS, 8 pin PS, 4 pin PS, hard drive, GPU, -same
-switched Bios on MB -same
-updated Bios using update button -Same
-press reset and power button on MB and nothing happens
-checked CPU (removed and replaced) -same
When starting Q-Code LEDs display a few numbers before shutting down. These numbers have changed during different troubleshooting steps. Right now 14 and 19 display with is just initialization for CPU and PCH.
I am getting convinced the MB is DOA. Any suggestions?
System specs:
-Asus Rampage IV Extreme X79 motherboard Black Edition
-Intel i7 4960X 3.6G 6C 12T 15M S2011
-G.SKILL Trident X Series 32GB (4 x 8GB) 240-Pin DDR3 SDRAM DDR3 2400 (PC3 19200)
-Antec HCP-1300 Platinum 1300W ATX12V / EPS12V
-512GB 2.5 SATA III 840 PRO SERIES INTER SAMSUNG
-NVIDIA QUADRO K5000
-NZXT CASE CA-H630F-M1 H630 FULL TOWER 2
-Noctua NH-D14 SE2011 140mm and 120mm SSO CPU Cooler
Troubleshooting tried:
Unplugged everything from motherboard,
just CPU and power supply -same
one ram stick in primary memory slot -same
just 24 pin power connector on motherboard connected -same
used different power supply and connected 24pin on motherboard -same
connected CPU fan, 24pin PS, 8 pin PS, 4 pin PS, hard drive, GPU, -same
-switched Bios on MB -same
-updated Bios using update button -Same
-press reset and power button on MB and nothing happens
-checked CPU (removed and replaced) -same
When starting Q-Code LEDs display a few numbers before shutting down. These numbers have changed during different troubleshooting steps. Right now 14 and 19 display with is just initialization for CPU and PCH.
I am getting convinced the MB is DOA. Any suggestions?